CP Veneer
The CP Veneer range is offered utilising both the CP Secure and the CP Light cores.
The choice is yours! The CP Veneer’s extensive range of finishes has an option to suit everyone’s taste. In addition the door can be spray finished leaving only the ironmongery to be added.
CP Veneer gives the finishing touch to any high quality project or home improvement.
Construction specification
Stiles
As per CP Secure55 & CP Light33
Rails
Sapele, 20 mm wide x 37 mm thick (640kg/m3)
Core
Outer: Albisia Falcata vertical lamels, 12.5 mm thick x 44 mm wide (200~300 kg/m3); inner: Albisia Falcata horizontal lamels, 12.5 mm thick x 44 mm wide (200~300 kg/m3)
Facings
MDF, chipboard, plywood, laminates or plastics
Face adhesives
Duplit 1P (D4 spec)
Lippings
8 mm hardwood
(550 kg/m3 min. density)
Lipping adhesive
Polyurethane
Leaf sizes
Configuration
(LSASD) dimensions = 2135 x 1051 mm ~ 2427 x 915 mm; (DASD & ULSASD) dimensions = 2135 x 1026 mm ~ 2377 x 915 mm. Overpanels of the same construction as the door panels may only be used with this doorset design if separated by a transom (max. heights = single leaf doorsets - 2000 mm, and double leaf doorsets - 1500 mm). Unequal leaf double doorsets are covered by this assessment with no restriction on the smaller leaf dimension, providing both leaf dimension remain within the permitted size limits..
Glazing
Max. glazed area = 0.72 m2
per leaf (assessed systems
see CHILT/RF02103)
Frame specification
Minimum section
Min. section = 70 x 32 mm
Material
Softwood or hardwood
Density
510 kg/m3 min.
Intumescent materials
Headjams & transomed overpanels. 15 x 4 mm fitted centrally in the leaf or frame reveal (increased to 20 x 4 mm if over 2135 x 915 mm). Name approved intumescent systems (leafs/glazing) are available with fitting instructions on request
Supporting technical data
Test reports: RF02103 & A02220